Remove your recoil starter and discard.
Remove original starter pulley. Retain original pulley bolt and o-ring. If you do not know what your recoil pulley is, STOP and let your local ATV technician do this for you.
Make sure surface is clean and then replace original starter pulley with boss provided in MacSim Guard Kit using original pulley bolt and o-ring.
Apply RTV silicone in groove of weep hole plug.
Insert plug in weep hole just enough for it to stay (do not try to push plug all the way in at this time).
After plug is inserted, apply a layer of RTV silicone across plug.
Install MacSim Guard with bolts provided in kit as follows: hold MacSim Guard against engine and hand tighten bolts. Make certain that the plug stays in place as you hand tighten bolts.
Tighten evenly to 5 ft. lbs. of torque. Do not use any power tools on shield bolts.
Disclaimer: MacSim Guard is not responsible for any damage resulting from improper installation.
Updated: 05/04/2008